On the Model E-342, the swivel board and work-light are optional, so you can design the ironing center to fit your needs. An illuminated rocker switch turns power on and off. The E-342 has a 42 inch ventilated steel ironing board, with an optional sleeve board. 42" Built In Ironing Center Features: Comes standard with birch veneer door. The user can adjust height of board after installation with a 4" differential between a maximum and minimum height when the swivel option is chosen. Ironing Board Cover and Pad are included. The interior has been painted a cool gray. Lighted Rocker On/Off Switch. Unit can be provided with a left hinged door (without garment hook) upon request. Right hinge is standard. Surface Mounting: Unit may be surface mounted (unit extends approximately 6 7/8" into room) or recessed (unit extends approximately 3" into room) into any wall with standard 16 inch center studs. See table in specification sheet (above) to determine desired ironing board height above the floor. The user can adjust height of board after installation with a 4" differential between a maximum and minimum height. Installation: Simple Install! Identify the location, cut and remove the drywall, slip the unit between the studs and attach it with the installation screws provided. All models are pre-assembled and ready to install. Fits between standard 2 x 4 studs on 16" centers. Install at the height of your choice, typically 34"-36" from the floor. Electrical: 120V, 15 Amps. Pigtails are provided in bottom of wire way for hookup to supply line. Make entrance into knockouts provided in top and bottom of wire way through left-hand vent hole.